2-氯苯乙烯

反应条件: temp:0.00; pressure:0.00; stir:

反应条件: temp:0.00; pressure:0.00; stir:; See reaction.notes.procedure_details.

实验步骤: To a solution of 1-chloro-2-ethenylbenzene (0.035 g, 0.25 mmol), triethylamine (2.5 mg, 0.025 mmol) and Clorox® aqueous sodium hypochlorite solution (1 mL, 16.1 mmol) in dichloromethane (5 mL) was added 4-[4-[(hydroxyimino)methyl]-2-thiazolyl]-1-[[5-methyl-3-(trifluoromethyl)-1H-pyrazol-1-yl]acetyl]piperidine (i.e. the product of Example 2, Step C) (0.10 g, 0.25 mmol) in dichloromethane (5 mL) dropwise over 1 h at 0° C. The reaction mixture was allowed to stir for 1 h, then filtered through Celite® diatomaceous filter aid, and concentrated under reduced pressure to give an oil, which was purified by column chromatography on silica gel using 50% ethyl acetate in hexane as eluant to give 73 mg of the title compound as a white foam, melting at 115-122° C. (crystallized from methyl acetate/petroleum ether). filtered through Celite® diatomaceous filter aid concentrated under reduced pressure to give an oil, which was purified by column chromatography on silica gel using 50% ethyl acetate in hexane as eluant to give 73 mg of the title compound as a white foam, melting at 115-122° C. (crystallized from methyl acetate/petroleum ether)

反应条件: temp:0.01; pressure:0.00; stir:; See reaction.notes.procedure_details.

实验步骤: To a vigrouosly stirred mixture of AD-mix (1.4 g) in water (5 ml) and t-butanol (5 ml) at 0° C. was added 1-Chloro-2-vinyl-benzene (0.140 grams, 1.0 mmole) and stirred at 0° C. for 2 hours. To the mixture sodium sulfite (1.5 g) was added and allowed to warm to room temperature for 1 hour. The mixture was extracted with methylene chloride. The combined extracts were washed with brine, dried over Na2SO4, filtered, and concentrated to give a colorless oil (0.190 g). MW 172.61; MS (m/e) 190 (M++18). to warm to room temperature for 1 hour The mixture was extracted with methylene chloride The combined extracts were washed with brine dried over Na2SO4 filtered concentrated

反应条件: temp:0.00; pressure:0.00; stir:; See reaction.notes.procedure_details.

实验步骤: Microwave irradiation of styrene 5 in either 1,2-dichloroethane (DCE) at 180° C. for 30 min or 1,1,1-trifluorotoluene at 180° C. for 180 minutes afforded the cyclopenta-naphthalene derivative 6 in nearly quantitative yield with no additional purification required of the final product (entries 1 and 2, Table 1). With conditions for an efficient and high yielding IMDA reaction utilizing a lower boiling solvent in hand, scope and limitations investigations were initiated. First, substitution on the aryl group was examined; exchanging a hydrogen atom for a chlorine atom was deemed valuable, enabling access to a wide-range of naphthalene derivatives via palladium-catalyzed cross coupling reactions. Moreover, a chlorine atom is more stable and accessible than other halides or groups used for coupling, such as triflates. Styrenyl derivatives 5b, 5c, and 5d were prepared and subjected to microwave irradiation. The para-chlorostyrene 5b gave 7-chloronaphthalene 6b in quantitative yield after 200 min (entry 3). The ortho-chlorostyrene 5c also produced only one product, the 5-chloronaphthalene 6c in 86% yield, even though two products are possible (entry 4). The meta-chlorostyrene 5d gave an inseparable 1.4:1 mixture of the 6-chloro- and 8-chloronaphthalenes, 6d and 6d′ in 79% yield (entry 5).

反应条件: temp:0.00; pressure:0.00; stir:; See reaction.notes.procedure_details.

实验步骤: Microwave irradiation of styrene 5 in either 1,2-dichloroethane (DCE) at 180° C. for 30 min or 1,1,1-trifluorotoluene at 180° C. for 180 minutes afforded the cyclopenta-naphthalene derivative 6 in nearly quantitative yield with no additional purification required of the final product (entries 1 and 2, Table 1). With conditions for an efficient and high yielding IMDA reaction utilizing a lower boiling solvent in hand, scope and limitations investigations were initiated. First, substitution on the aryl group was examined; exchanging a hydrogen atom for a chlorine atom was deemed valuable, enabling access to a wide-range of naphthalene derivatives via palladium-catalyzed cross coupling reactions. Moreover, a chlorine atom is more stable and accessible than other halides or groups used for coupling, such as triflates. Styrenyl derivatives 5b, 5c, and 5d were prepared and subjected to microwave irradiation. The para-chlorostyrene 5b gave 7-chloronaphthalene 6b in quantitative yield after 200 min (entry 3). The ortho-chlorostyrene 5c also produced only one product, the 5-chloronaphthalene 6c in 86% yield, even though two products are possible (entry 4). The meta-chlorostyrene 5d gave an inseparable 1.4:1 mixture of the 6-chloro- and 8-chloronaphthalenes, 6d and 6d′ in 79% yield (entry 5).

反应条件: temp:0.00; pressure:0.00; stir:; See reaction.notes.procedure_details.

实验步骤: Microwave irradiation of styrene 5 in either 1,2-dichloroethane (DCE) at 180° C. for 30 min or 1,1,1-trifluorotoluene at 180° C. for 180 minutes afforded the cyclopenta-naphthalene derivative 6 in nearly quantitative yield with no additional purification required of the final product (entries 1 and 2, Table 1). With conditions for an efficient and high yielding IMDA reaction utilizing a lower boiling solvent in hand, scope and limitations investigations were initiated. First, substitution on the aryl group was examined; exchanging a hydrogen atom for a chlorine atom was deemed valuable, enabling access to a wide-range of naphthalene derivatives via palladium-catalyzed cross coupling reactions. Moreover, a chlorine atom is more stable and accessible than other halides or groups used for coupling, such as triflates. Styrenyl derivatives 5b, 5c, and 5d were prepared and subjected to microwave irradiation. The para-chlorostyrene 5b gave 7-chloronaphthalene 6b in quantitative yield after 200 min (entry 3). The ortho-chlorostyrene 5c also produced only one product, the 5-chloronaphthalene 6c in 86% yield, even though two products are possible (entry 4). The meta-chlorostyrene 5d gave an inseparable 1.4:1 mixture of the 6-chloro- and 8-chloronaphthalenes, 6d and 6d′ in 79% yield (entry 5). with no additional purification With conditions for an efficient and high yielding were prepared irradiation

反应条件: temp:0.00; pressure:0.00; stir:; See reaction.notes.procedure_details.

实验步骤: A solution of (Z)-1,3-dihydro-4-iodo-3-[(1H-pyrrol-2-yl)methylene]-2H-indol-2-one (39 mg, 0.116 mmol) (from Example 71 above), triethylamine (65 μL, 0.464 mmol), tri-o-tolylphosphine (7 mg, 0.023 mmol) (Aldrich), palladium(ll) acetate (2 mg, 0.009 mmol) (Aldrich), and 2-chlorostyrene (24 mg, 0.173 mmol) (Aldrich) in 3 mL of dry N,N-dimethylformamide was heated at 85° C. under a nitrogen atmosphere for 20 h. The reaction mixture was allowed to cool to room temperature and then directly purified by flash chromatography (Merck Silica gel 60, 230-400 mesh, 5% ethyl acetate-benzene elution) to yield pure 4-[(E)-2-(2-chlorophenyl)-ethenyl]-1,3-dihydro-(Z)-3-[(1H-pyrrol-2-yl)methylene]-2H-indol-2-one as a yellow solid. (Yield 27 mg, 67%; mp=257-258° C.). directly purified by flash chromatography (Merck Silica gel 60, 230-400 mesh, 5% ethyl acetate-benzene elution)

反应条件: temp:0.00; pressure:0.00; stir:; See reaction.notes.procedure_details.

实验步骤: A solution of (Z)-1,3-dihydro-4-iodo-3-[(1H-pyrrol-2-yl)methylene]-2H-indol-2-one (39 mg, 0.116 mmol) (from Example 71 above), triethylamine (65 μL, 0.464 mmol), tri-o-tolylphosphine (7 mg, 0.023 mmol) (Aldrich), palladium(ll) acetate (2 mg, 0.009 mmol) (Aldrich), and 2-chlorostyrene (24 mg, 0.173 mmol) (Aldrich) in 3 mL of dry N,N-dimethylformamide was heated at 85° C. under a nitrogen atmosphere for 20 h. The reaction mixture was allowed to cool to room temperature and then directly purified by flash chromatography (Merck Silica gel 60, 230-400 mesh, 5% ethyl acetate-benzene elution) to yield pure 4-[(E)-2-(2-chlorophenyl)-ethenyl]-1,3-dihydro-(Z)-3-[(1H-pyrrol-2-yl)methylene]-2H-indol-2-one as a yellow solid. (Yield 27 mg, 67%; mp=257-258° C.). directly purified by flash chromatography (Merck Silica gel 60, 230-400 mesh, 5% ethyl acetate-benzene elution)

反应条件: temp:0.00; pressure:0.00; stir:; See reaction.notes.procedure_details.

实验步骤: To a solution of 1-chloro-2-ethenylbenzene (0.035 g, 0.25 mmol), triethylamine (2.5 mg, 0.025 mmol) and Clorox® aqueous sodium hypochlorite solution (1 mL, 16.1 mmol) in dichloromethane (5 mL) was added 4-[4-[(hydroxyimino)methyl]-2-thiazolyl]-1-[[5-methyl-3-(trifluoromethyl)-1H-pyrazol-1-yl]acetyl]piperidine (i.e. the product of Example 2, Step C) (0.10 g, 0.25 mmol) in dichloromethane (5 mL) dropwise over 1 h at 0° C. The reaction mixture was allowed to stir for 1 h, then filtered through Celite® diatomaceous filter aid, and concentrated under reduced pressure to give an oil, which was purified by column chromatography on silica gel using 50% ethyl acetate in hexane as eluant to give 73 mg of the title compound as a white foam, melting at 115-122° C. (crystallized from methyl acetate/petroleum ether). filtered through Celite® diatomaceous filter aid concentrated under reduced pressure to give an oil, which was purified by column chromatography on silica gel using 50% ethyl acetate in hexane as eluant to give 73 mg of the title compound as a white foam, melting at 115-122° C. (crystallized from methyl acetate/petroleum ether)

反应条件: temp:0.00; pressure:0.00; stir:; See reaction.notes.procedure_details.

实验步骤: Compound 65 was prepared from 2,3-dichloroaniline, glyoxylic acid and 2-chlorostyrene by the automated process.

反应条件: temp:0.00; pressure:0.00; stir:; See reaction.notes.procedure_details.

实验步骤: Compound 52 was prepared by the basic process from 5.0 mmol 4-chloroaniline, 5.5 mmol ethylglyoxalate solution (50% toluene), 15.0 mmol 2-chlorostyrene and 5.0 mmol trifluoroacetic acid in 30.0 ml acetonitrile.

反应条件: temp:0.00; pressure:0.00; stir:; See reaction.notes.procedure_details.

实验步骤: Compound 33 was prepared by the basic process from 5.0 mmol 3,5-dichloroaniline, 5.5 mmol ethylglyoxalate solution (50% toluene), 15.0 mmol 2-chlorostyrene and 5.0 mmol trifluoroacetic acid in 30.0 ml acetonitrile.